3. The pinches move down into position.
4. T2500 and T3500 only: The printer will initialize the Scanner and start checking it.
5. The carriage and service station move to the home position
6. The printer checks the status of supplies and the printhead, and then initializes the Ink Supply Stations.
7. Servicing routines are launched. The routines refresh the printhead depending on the time that the
printer has been off. The Front Panel shows “Preparing Print System”.
8. The paper path subsystems are initialized by exercising the ramps and rewinder, checking if there is
media present over the Media Sensor.
9. At the end of the process, the home screen appears in the Front Panel.
Front Panel Menu Map
The following tables show the front panel menu layout.
14 Chapter 1 Printer fundamentals ENWW
To Next Page
Loading...
