12. Put the left end cover back on the printer, aligning the protrusions with the holes in the printer.
13. Close the ink cartridge cover.
14. At the front panel, turn the printer back on. The printer checks that the cutter has been correctly
installed. Look at the front panel and follow its instructions if there is any problem.
Maintain the ink cartridges
During the normal lifetime of a cartridge, no specific maintenance is required. However, in order to
maintain the best print quality, replace a cartridge when it reaches its expiration date. The printer's front
panel notifies you when any cartridge reaches its expiration date.
You can also check a cartridge's expiration date at any time: see
Check printer status on page 93.
See also
Handling ink cartridges and printheads on page 81.
Move or store the printer
If you need to move or store the printer, prepare it correctly to avoid possible damage to it. To prepare
the printer, follow the instructions below.
1. Do not remove the ink cartridges or printheads.
2. Make sure that no paper is loaded.
3. Make sure that the printer is idle.
4. Disconnect any cables connecting the printer to a network or a computer.
ENWW Maintain the ink cartridges 97
Printer maintenance
To Next Page
Loading...
