how do I... maintenance procedures
djcc-3.htm[28/10/2014 15:48:42]
2. Power ON the scanner.
3. The scanner should be warm - apply only for the HP Designjet
HD Pro Scanner.
Make sure that the scanner has been turned on for at least one hour
prior to calibration. Slight light intensity changes and camera shifting
can occur just after turning the scanner on and the warm-up time
will ensure that light conditions and camera heights have stabilized.
4. Select the Setup tab.
5. Press the Options button. Select Scanning
6. Press the Calibrate button to start the Calibration wizard.
Select either Camera Alignment or Full Calibration.
To Next Page
Loading...
