how do I... maintenance procedures
djcc-3.htm[28/10/2014 15:48:42]
On scanners with white pressure-platen - white background
platen (white metal area) is fixed in the scanning area lid. Hold
the lid open as you clean. Warning - do not attempt to remove
the white background platen for cleaning it. Removing the
white background platen is only necessary when replacing
it.
On scanners with white pressure rollers - the white rollers are at
the bottom between the transport rollers.
Wipe the white platen/rollers with a lint-free cloth and a mild,
streak-free, glass cleaner. Apply the cleaner to the cloth and
first and then wipe the white area.
6. Clean the upper and lower transport rollers and surrounding
area.
Wipe the rollers with a lint-free cloth and a mild, streak-free,
glass cleaner.
Caution: do not use abrasives, acetone, benzene or fluids that
contain these chemicals.
7. Dry the white background platen, transport rollers and
surrounding area fully using a separate clean, dry lint-free
cloth.
8. Clean also the scanner feed surface so dirt and dust are not
dragged into the scan area with the original.
9. Close the scanner cover. The locks will reengage.
You can now calibrate the scanner.
camera calibration (including camera alignment)
Before you calibrate, make sure that you have cleaned the scan area.
An unclean scanning area will give you imprecise calibration results.
Camera calibration is a fully automatic process that you only need to
activate through the wizard and then leave to run on its own.
1. Connect the scanner power cable.
To Next Page
Loading...
