how do replace scanner parts
djcc-96.htm[28/10/2014 15:48:44]
4. Lift the glass plate from the scanner bed
a. Tilt and lift the glass back until the hooks become free of
their pins.
b. Lift the glass plate from the scanner..
5. Insert a new glass plate
Reverse the above operations to reinsert a new glass-plate –
Carefully set the new glass plate down into the scan area.
a. Fit the new glass-plate's lever hooks on to the round pins on
each side
of the scanner.
b. While supporting the glass-plate with fingers on the lever
handles, carefully ease the glass-plate down backwards (away
from your body) so it falls into place.
c. Close the scan area lid.
NOTE: It is recommended to clean the new glass-plate after
inserting it in the scanner and before scanning.
NOTE: It is recommended to recalibrate after changing the
glass-plate..
To Next Page
Loading...
