how do replace scanner parts
djcc-96.htm[28/10/2014 15:48:44]
3. Tilt the glass plate back
At the end of each glass plate lever there is a small hook that
rests on a round pin. The hook holds the glass plate in place on
the scanner's chassis while also letting you un-attach the glass
plate from the scanner. You start by tilting the glass plate
upwards on the round pin's axis.
a. With both arms, pull simultaneously on the left and right
levers to tilt the glass-plate towards your body on the round
pin's axis.
b. Tilt the glass plate back on the hooks until it is completely
free of its resting place on the scan area bed and you can
access the glass pate edges.
To Next Page
Loading...
