how do replace glass plate
djcc-96a.htm[28/10/2014 15:48:45]
you are here: welcome how do I...? replace glass - HP Designjet SD Pro Scanner
HP Designjet Scanner
how do I...?
the problem is...
alphabetical index
how do I replace the glass plate? - HP Designjet SD Pro
Scanner
The following instructions apply for scanner model HP Designjet SD
Pro Scanner only (see your documentation to identify the scanner
model on your sysem.
Small scratches on the glass plate can reduce scanning quality.
Replacement with a new glass plate can be recommended by the
program.
You can replace the glass on your HP Designjet SD Pro Scanner.
Replacing the glass plate
1. Power off and open the lid
Turn the scanner power off and disconnect the power plug.
Open the scanner lid by pushing the 2 backside lid release
buttons towards the middle of the scanner
2. Identify the latch release buttons
The illustration below shows the scanner from above with its
lid open. The illustration indicates the key parts and buttons
you need to recognize when replacing a worn glass plate.
The glass plate is held and locked in place with 2 small white-
colored latches. Each latch can be released from the glass plate
by pressing down on its corresponding latch release button
(see iluustration below). Each latch release button is placed in a
square hole just under the latch it releases.
To Next Page
Loading...
