how do replace glass plate
djcc-96a.htm[28/10/2014 15:48:45]
3. Detatching the glass plate – free the 1st latch
Stand at the front of the scanner. You start at the scanner’s
right side. See the illustration below.
a. Detaching the first (rightmost) latch requires a sharp, flat
tool such as a pen or a small screwdriver.
NOTE: Detaching the remaining latch will not require use of a
tool.
b. Locate the arrow label at the scanner’s right side.
c. Position the tool just under the glass plate edge where the
arrow label indicates. At the same time; press down on the
latch release button in the first (rightmost) square hole.
d. Carefully, use the tool to flip the edge of the glass upwards
until it comes above and free of the white latch that held it
down.
e. Release the latch release button.
4. Detaching the glass plate – free the 2nd latch
After freeing the first latch in the previous step, freeing the 2nd
To Next Page
Loading...
