how do replace glass plate
djcc-96a.htm[28/10/2014 15:48:45]
latch is easy. See the illustration below.
a. Press down on the latch release button in the 2nd square
hole.
b. The 2nd latch will release its grip and the glass will pop up
over the latch.
5. Detaching the glass plate – Tip the glass plate edge
upwards
After releasing the latches, the glass plate is now free for
removal.
a. Stand at the front side of the scanner.
b. Insert you thumbs under the glass plate edge around the
middle area as shown in the illustration on the right.
NOTE: If you can’t get your thumbs under the glass - use the
sharp, flat tool from step 5 to tip the glass high enough to get a
thumb underneath.
c. Tip the glass back and up so its two ends are free.
d. Move your hands, one at a time, to each end of the glass.
e. Apply light pressure with each hand as you lift the glass out
of the scanner.
To Next Page
Loading...
