how do I set the scanner system power up/down timer?
djcc-64.htm[28/10/2014 15:48:46]
you are here: welcome how do I...? scanner system power up/down timer
HP Designjet Scanner
how do I...?
the problem is...
alphabetical index
how do I set the scanner system power up/down timer?
NOTE: The availability of the power timer feature depends on your
scanner model.
Automatic power up/down saves energy and will lengthen the life span
for your scanner lamp. Typically, you would set the scanner to power
down sometime after work hours and power up at least an hour before
you arrive in the morning so your system is warmed up and ready for
use.
Note that The following applies when the power up/down timer is set:
If a scan is being done when power off time is reached, automatic power
off is delayed by 15 minutes.
If the scanner is manually started, 3 hours will have to pass before it
goes into standby.
to set the scanner system power up/down timer...
1. Press the Setup tab
2. Press Options > System > Advanced
3. Press the Sleep Timers button
4. Use sleep time out - select this option if you wish the scanner to
go into sleep mode after an idle time interval that you
determine through the Sleep timeout button.
5. The 2 options: Use Sleep/wakup on weekdays and Use
Sleep/wakup on weekends allow you to define the days you
wish the scanner to go into sleep or wake modes. For example,
you may only want to have the scanner power up and off
during work days i.e., week days.
To Next Page
Loading...
