how do I change the insertion slot height?
djcc-5.htm[28/10/2014 15:50:02]
When the insertion slot height is not in the Normal position, the
following warning is displayed below the preview window on your touch
screen:
Paper Guide in Extended Position
to adjust the insertion slot for thick media...
1. Press and hold down the ATAC Up-key on your operator’s
panel to raise the pressure platen and enlarge the insertion
slot until there is room to insert the thick original.
2. The ATAC Indicator blinks yellow indicating the scanner is in
ATAC mode.
3. Insert the thick original evenly for a straight scan path.
4. Press and hold the ATAC Down-Key to lower the pressure-
platen until the pressure-platen rests on the original and stops
on its own.
5. The ATAC indicator will stop blinking and remain yellow when
the pressure-platen is positioned correctly and is ready for
thick media scanning.
6. When finished scanning, and you have ejected the thick
original, press and hold the ATAC Down-Key to return the
pressure-platen to its normal position. The ATAC indicator LED
will turn off.
To Next Page
Loading...
