HP Designjet - The Problem: Job Held in Queue; Resolving Print Queue Issues

the problem is a job held in queue
djcc-103.htm[28/10/2014 15:50:07]
you are here: welcome the problem is... job held in queue
HP Designjet Scanner
how do I...?
the problem is...
alphabetical index
the problem is that the image is not printed - job held
in queue
If your printer does not start printing the image, the job may be held
up in the print queue. With some printers you can view the printer
queue to see if that is the case. To do so, press the Print queue
button at the bottom of the screen.
There can be a number of reasons why the printer is holding the job
and not printing. Check and fix any of the causes listed below:
if your job is held in the queue
1. The printer may hold the job if the media profile selected is not
correct in relation to the media in the printer. If you find that
the media profile setting is incorrect - see: ...how do I select a
media profile.
If you find that a media profile for the printer's current media
does not exist in your system - See... how do I create a new
media profile.
2. The printer may hold the job if the output size width defined for
the job is wider than the actual media roll width loaded in the
printer. If this is the case - change the roll or the output size
width.
printing instructions legal information
© 2002-2014 Hewlett-Packard Company