how do I set the output quality?
djcc-77.htm[28/10/2014 15:45:15]
1. Press the Scan Tab.
2. Press the Scan Resolution button.
Scan Quality
Scan Resolution - You set a scan resolution value in dpi (dots
per inch).
To use Auto dpi setting, you check the Auto field and then
choose one of the Print Quality settings. This ensures that
the Scan (to file) quality setting will match your intentions
for printing the file later on. The Print Quality setting itself
is not used in the Scan to file process. The program
selects a scan to file dpi setting that is best for the Print
Quality setting you chose (Fast, Normal or Best). The
automatically selected dpi value is displayed next to the
field (300 dpi in example above).
Uncheck Auto to set your own dpi value.
Descreen tells the scanner to scan with the scanner’s optical
resolution and relay the data to the software without
interpolation. Optimal conversion to the set dpi or quality
is then performed by the software. Gives superior results
with raster originals. Scanning speed is reduced.
Turbo: You set the Scan resolution value or Auto and then
select Turbo. This will basically double the scanning
speed but with a reduction on image quality. Turbo
resolution processing involves speeding up the paper’s
movement, reduction of captured scan data in the scan
direction and resampling to create the image resolution
as set in Scan Resolution or Auto options. Turbo mode
has no effect for resolutions below 300 dpi.
To Next Page
Loading...
