how do I set the printer media width?
djcc-66.htm[28/10/2014 15:45:16]
Setting the paper media width on printers WITHOUT support for
automatic media width detection...
1. At start up - The program will set the media width value stored
with the printer driver. This is normally the maximum output
width of the printer. If you are using a roll smaller than the
maximum width of the printer, you will need to change the
width manually. Access the Setup tab>Printer>Tool
button>Advanced dialog. Press the Media width button to enter
a new value with the on-screen keyboard and press the
keyboard's Enter key to confirm. The media width value will be
displayed in the Media width button.
2. If you change the paper roll to one of another width - You need
to change the width value manually. Access the Setup
tab>Printer>Tool button>Advanced dialog. Press the Media
width button to enter a new value with the on-screen keyboard
and press the keyboard's Enter key to confirm. The media
width value will be displayed in the Media width button.
3. Select OK to finish.
printing instructions legal information
© 2002-2014 Hewlett-Packard Company
To Next Page
Loading...
