Chapter 5 - Maintaining and troubleshooting76
Replacing the ink service module
The replaceable ink service module holds waste ink from the black print cartridge. When it is almost full,
the printer lights will prompt you to replace it. See Printer light patterns.
When the ink service module is full, the printer will stop printing. If you have a new ink service module,
install it immediately by following the instructions that come with it.
Otherwise, visit http://www.hp.com/support/dj460
or see Support and warranty to get a replacement.
In the meantime, remove the black print cartridge to continue printing. The printer can print using only the
tri-color print cartridge but the color results and print speed will be affected. See Printing with a single print
cartridge.
CAUTION: Allowing the ink service module to fill completely can result in black ink spillage. Take care to
avoid spilling the ink in the ink service module. Ink can permanently stain fabric and other materials.
NOTE: If you have installed the Toolbox (Windows), you can choose to display error messages on your
screen when there is a problem with your printer. See Installing the printer software and sharing the printer
(Windows).
To Next Page
Loading...
