resetting the printer to the factory default configuration
Once the printer is configured on an ethernet, its configuration settings are saved in its memory.
You may need to reset the printer to its factory default configuration, if you cannot:
● Print to the printer
● Open the printer's internal web page
Follow these steps to reset the printer to the factory default configuration:
1. Verify that the printer is powered off.
2. Press and hold down the Cancel button ( X ).
3. While holding down the Cancel button, press the Power button to turn the printer on.
4. Release the Cancel button.
5. Verify that all three printer lights simultaneously blink twice.
all three lights simultaneously blink twice
If the lights do not blink, then repeat steps 1-4.
To Previous Page
Loading...