32
2 Put the transparencies in your printer with the rough side down and
the adhesive strip forward. (You can peel off the adhesive strip after
printing.)
3 Slide in the green paper adjusters, just as you would for plain paper.
Push the IN drawer back in and flip the OUT tray down.
4 Print the transparency.
5 Be patient.
Because the printer uses more ink, lays the colors down more slowly,
and allows for a longer drying time between sheets, transparencies
take a while to print.
■ Change the paper type in the HP print settings box back to
Plain Paper
or to whatever is appropriate for what you’ll be printing next.
■ Remove any remaining transparencies from the IN drawer and replace
them with plain paper or whatever you’ll be using next.
Adhesive strip forward, tape
side up
Rough side down
AFTER PRINTING
What If
THE INK NEVER
DRIES OR THERE
ARE CRACKS IN
THE SOLID BLOCKS
OF COLOR
• You might have
printed on the wrong
side of the transpar-
ency. Make sure to
put it into the printer
rough side down.
• You might be trying
to print on a trans-
parency that wasn’t
meant for an inkjet
printer.
T
HE QUALITY
ISN’T WHAT YOU
WERE EXPECTING
You might not have
chosen the right paper
type and print quality.
Follow the steps in the
procedure above, and
try printing again.
Handy Hints
PROTECT YOUR
TRANSPARENCIES
If you want to make
notes on your trans-
parency as you talk,
print the transparency
as a flipped document
(described on
page 18).
To Next Page
Loading...