Removal and replacement procedures 36
Power cable management
Item PSU cable label Connects to
1 P1 PWR_CN on the
system board
2 P2 CN4 on the system
board
3 P3 Optical disc drive
4 P8 2
nd
hard drive
5 P9 1
st
hard drive
Hard disk drive
Hard drives installed in the server are labeled as HDD 1 and HDD 2, from left to right, when viewed
from the front of the server.
The drive bays can accommodate large form factor (LFF) non-hot-plug SAS or SATA hard drives. The
following drive capacities are supported.
• Non-hot-plug SAS HDD – 72-, 146-, and 300-GB
• Non-hot-plug SATA HDD – 80-, 160-, 250-, 500-, and 750-GB
IMPORTANT: SAS hard drives require that you first install the SAS controller board and SAS
HDD/LED cable option kits. For instructions on how to install these option kits, go to page 61.
To Next Page
Loading...
