Hardware options installation 62
10.
Secure the 10G NIC connectors to the chassis with the retaining screw.
11. Install the RJ-45 plugs on the bottom two RJ-45 connectors on the rear panel.
12. Install the access panel (on page 27).
13. Slide the server back into the rack.
14. Connect the network cables.
15. Power up the server (on page 25).
Battery-backed write cache module
The HP BBWC protects against hard boot, power, controller, and system board failures. The server
supports the following battery-backed options:
• 256-MB cache module (standard)
• 512-MB cache module (optional)
To Next Page
Loading...
