To Next PageTo Next Page
Need help?Do you have a question about the HP ProLiant DL580 Gen9 and is the answer not in the manual?
General| Memory | Up to 6TB DDR4 |
|---|---|
| Memory Slots | 96 DIMM slots |
| Form Factor | 4U rack |
| Processor | Intel Xeon E7-4800 v3/v4, Intel Xeon E7-8800 v3/v4 |
| Expansion Slots | 9 PCIe 3.0 slots |
| Network | Four embedded 1Gb Ethernet ports (optional 10Gb/40Gb) |
| Power Supply | Up to 4 hot-plug redundant power supplies |
| Management | HP iLO 4 (Integrated Lights-Out) standard |
| RAID | HP Smart Array controllers |
| Operating System Support | Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware |
Essential safety precautions and pre-removal steps for component servicing.
Procedures for powering down, extending, and removing the server from its rack.
Steps to remove the access panel and prepare for component access.
Detailed procedures for replacing memory cartridges, DIMMs, heatsinks, and processors.
Procedures for replacing server drives and hot-plug power supplies.
Procedures for replacing expansion boards, LOM, and I/O boards.
Steps for replacing the system board battery.
Using the system's UEFI interface for configuration and diagnostics.
Utilizing diagnostic software for server health checks and troubleshooting.
Monitoring and recording server hardware and configuration changes for issue diagnosis.
Identifying front panel parts, buttons, and status indicators.
Identification of rear panel ports, slots, and power supply bays.
Locating DIMM slots and understanding DIMM fault LEDs and identification buttons.
Identifying drive bays and understanding hot-plug drive LED definitions.
Operating and shipping environmental limits for the server.
Physical dimensions and weight of the server.
Details on available power supply options and their electrical ratings.
