Removal and replacement procedures 65
3.
Remove the server from the rack (on page 27).
4. Remove the access panel (on page 28).
5. Disconnect all cables from the card.
6. Remove the card.
To replace the component, reverse the removal procedure.
Express Bay backplane
CAUTION: To prevent damage to electrical components, take the appropriate anti-static
precautions before beginning any system installation. Improper grounding can cause
electrostatic discharge.
To remove the component:
1. Power down the server (on page 26).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Remove the server from the rack (on page 27).
4. Remove the access panel (on page 28).
To Next Page
Loading...
