Removal and replacement procedures 37
6.
Disconnect the cable from the bezel.
To replace the component, reverse the removal procedure.
USB/video/Discovery Services cable
1. Power down the server (on page 26).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Extend the server from the rack (on page 26).
4. Remove the access panel (on page 28).
5. Remove the processor memory drawer (on page 29).
6. Remove the SPI board (on page 30).
7. Remove the left bezel ("Left bezel (USB/video)" on page 36).
To Next Page
Loading...
