Need help?Do you have a question about the HP ProLiant DL580 Generation 3 and is the answer not in the manual?
General| Processor | Up to 4 Intel Xeon MP processors |
|---|---|
| Maximum Memory | 64 GB DDR2 SDRAM |
| Drive Bays | Up to eight hot-plug drive bays (SAS or SATA) |
| RAID Support | Integrated RAID controller (various options available) |
| Power Supply | Redundant power supplies |
| Form Factor | 4U rack-mount |
| Network | Integrated NC7782 dual-port Gigabit NIC (PCI-X) |
| Operating System Support | Windows, Linux, NetWare |
Explains the status and function of front panel LEDs and buttons.
Details components and LED indicators on memory boards.
Describes the LEDs associated with the processor modules.
Identifies and describes components located on the server's rear panel.
Explains the LED indicators for the server's power supplies.
Explains the function and positions of the system maintenance switch.
Interprets combinations of LEDs for hot-plug SCSI hard drives.
Interprets LED combinations for SAS and SATA hard drives.
Instructions on how to power on the server.
Procedures for safely powering down the server.
Steps to extend the server for access to components.
Instructions on how to remove the server's access panel.
Guidelines for selecting an optimal operating environment.
Requirements for server installation space and airflow.
Recommended ambient operating temperature ranges for the server.
Electrical power requirements and guidelines for installation.
Procedures for proper electrical grounding of the server.
Information on installing processor modules and PPMs.
Guidelines for installing hot-plug SCSI hard drives.
Procedures for installing a redundant hot-plug power supply.
Information on installing the Battery-Backed Write Cache.
Describes the server's expansion slots and mezzanine options.
Steps to install the PCI-X Hot Plug Mezzanine Option.
Instructions for installing non-hot-plug expansion boards.
General information about server memory configuration.
Details the Advanced ECC memory protection mode.
Procedures for installing and replacing memory boards and DIMMs.
Steps to configure memory settings in RBSU.
Guidelines for cabling storage devices.
Cabling instructions for the PCI-X Hot Plug mezzanine board.
Cabling configurations for hot-plug SCSI drives.
Cabling for hot-plug SAS hard drives.
Overview of available configuration tools.
Information on the RDP software for server deployment.
List and overview of server management tools.
Overview of various diagnostic tools for the server.
Step-by-step procedures for diagnosing server problems.
Crucial safety guidelines for server maintenance.
Steps to prepare the server for troubleshooting.
Explains POST error messages and beep codes.
FCC compliance information for the server.
EU directives and conformity marking information.
Safety precautions for battery handling and replacement.
Operating and shipping environmental parameters for the server.
Physical dimensions and weight of the server.
Information to have ready before contacting HP support.
Contact details for HP authorized resellers and support.
Overview of HP's customer self-repair program.
Definition of the DIMM acronym (dual inline memory module).
Definition of the ECC acronym (error checking and correcting).
Definition of the iLO acronym (Integrated Lights-Out).
Definition of the POST acronym (Power-On Self Test).
Definition of the RAID acronym (redundant array of inexpensive disks).
Definition of the RBSU acronym (ROM-Based Setup Utility).
Definition of the RILOE II acronym (Remote Insight Lights-Out Edition II).
Definition of the USB acronym (universal serial bus).
To Next Page