108 HP ProLiant DL580 Generation 3 Server User Guide
7. Close the ejector lever, and lock the locking switch.
NOTE: The board status LED might flash green for several
minutes while the board is rebuilding.
8. Configure the memory ("Configuring the memory" on page 111) if
applicable.
9. Reference the memory board LEDs ("Memory board components and LEDs"
on page 12
) to be sure that the memory board is functioning properly.
Removing and installing a memory board (non-hot-plug)
1. Power down the server ("Powering down the server" on page 37).
2. Unlock the locking switch, and open the release latch.
To Next Page
Loading...
