70 HP ProLiant DL580 Generation 3 Server User Guide
3. Install the hard drive.
4. Determine the status of the hard drive from the hot-plug SAS hard drive LED
combinations ("SAS and SATA hard drive LED combinations" on page 31
).
Redundant hot-plug power supply
The server supports a second hot-plug power supply to provide redundant power
to the server in the event of a failure in the primary power supply. You can install
or replace a second hot-plug power supply without powering down the server.
WARNING: To reduce the risk of electric shock or damage to
the equipment:
• Do not disable the power cord grounding plug. The grounding
plug is an important safety feature.
• Plug the power cord into a grounded (earthed) electrical outlet
that is easily accessible at all times.
• Unplug the power cord from the power supply to disconnect
power to the equipment.
• Do not route the power cord where it can be walked on or
pinched by items placed against it. Pay particular attention to
the plug, electrical outlet, and the point where the cord extends
from the server.
To Next Page
Loading...
