Hardware options installation 65
To install the component:
1. Back up all data.
2. Close all applications.
3. Power down the server (on page 25).
CAUTION: In systems that use external data storage, be sure that the server is the first unit to
be powered down and the last to be powered back up. Taking this precaution ensures that
the system does not erroneously mark the drives as failed when the server is powered up.
4. Extend the server from the rack (on page 25).
5. Remove the access panel (on page 26).
6. Remove the SPI board (on page 28).
7. Install the FBWC module.
8. Connect the cable.
9. Install the capacitor pack.
To Next Page
Loading...
