Computer Setup menus
The menu tables in this section provide an overview of Computer Setup options.
NOTE: Some of the Computer Setup menu items listed in this chapter may not be supported by
your computer.
File menu
Select To do this
System Information ● View identification information for the computer and the
batteries in the system.
●
View specification information for the processor, cache
and memory size, system ROM, video revision, and
keyboard controller version.
Set System Date and Time Set or change the date and time on the computer.
System Diagnostics Displays the following information:
●
System Information
◦
Identification information for the computer and the
batteries in the system.
◦ Specification information for the processor, cache
and memory size, system ROM, video revision,
and keyboard controller version.
●
Start-up Test—Verifies the system components needed
for starting the computer.
●
Run-In Test—Runs a comprehensive check on system
memory.
●
Hard Disk Test—Runs a comprehensive self-test on
any hard drive in the system.
●
Memory Test—Runs a comprehensive test on any
memory installed in the computer.
●
Battery Test—Runs a comprehensive test on any
batteries installed in the computer.
●
Error Log—Displays a log file if any errors have
occurred.
Restore Defaults Replace the configuration settings in Computer Setup with
the original factory settings. (Hard drive mode, password
settings, and security settings are not changed when you
restore the factory settings.)
Reset BIOS security to factory default Restore the BIOS security settings to the factory default.
Ignore Changes and Exit Cancel any changes entered during the current session.
Then exit and restart the computer.
Save Changes and Exit Save any changes entered during the current session. Then
exit and restart the computer. Your changes go into effect
when the computer restarts.
Computer Setup menus 83
To Next Page
Loading...
Need help?
General
Weight and Dimensions
