HP EliteBook 6930p - Diagnostics Menu

Select To do this
Change Password Enter, change, or delete a BIOS administrator password.
HP SpareKey Enrollment Enroll or reset HP SpareKey, which is a set of security questions and answers used if you
forget your password.
DriveLock Passwords
●
Enable/disable DriveLock on any computer hard drive (enabled by default).
●
Change a DriveLock user password or master password.
NOTE: DriveLock settings are accessible only when you enter Computer Setup by turning
on (not restarting) the computer.
Automatic DriveLock Enable/disable Automatic DriveLock support.
Disk Sanitizer Run Disk Sanitizer to destroy all existing data on the primary hard drive.
CAUTION: If you run Disk Sanitizer, the data on the primary hard drive is destroyed
permanently.
System IDs Enter a user-defined computer asset tracking number and ownership tag.
Always Prompt for HP SpareKey
Enrollment
Enable/disable a prompt for HP SpareKey enrollment.
Diagnostics menu
Select To do this
System Diagnostics menu
●
F1 System Information—Displays the following information:
◦
Identification information for the computer and the batteries in the system.
◦
Specification information for the processor, cache and memory size, system
ROM, video revision, and keyboard controller version.
●
F2 Start-up Test—Verifies the system components needed for starting the computer.
●
F3 Run-In Test—Runs a comprehensive check on system memory.
●
F4 Hard Disk Test—Runs a comprehensive self-test on any hard drive in the system.
106 Chapter 5 Computer Setup