2. Loosen the 4 hard drive screws (1). Slide the hard drive (2) forward, and then remove it (3).
3. If it is necessary to disassemble the hard drive, perform the following steps:
a. Remove the four Phillips PM3.0×3.0 screws (1) that secure the hard drive bracket to
the hard drive.
b. Slide the hard drive bracket (2) off the hard drive. The hard drive bracket and screws are available
in the Hard Drive Hardware Kit, spare part number 730793-001.
Reverse this procedure to reassemble and install the hard drive.
Component replacement procedures 55
To Next Page
Loading...
