Solid-state drive (SSD)
Description Spare part number
512-GB 752240-001
256-GB, Self-encrypting drive (SED), SSD 731194-001
256-GB, Self-encrypting drive (SED), OPAL 766013-001
256-GB 766643-001
256-GB, locked (for use only in HP EliteBook 740/840 and ZBook 14 models) 780090-001
256-GB, Self-encrypting drive (SED), locked 799300-001
256-GB, locked, SMSG 800584-001
240-GB 732680-001
180-GB 732678-001
180-GB, Self-encrypting drive (SED) 786173-001
128-GB, SSD (for use only in HP EliteBook 750/850 models) 744483-001
128-GB, locked (for use only in HP EliteBook 740/840 and ZBook 14 models) 766678-001
128-GB, locked, SanDisk 795941-001
120-GB, SSD 732681-001
120-GB, M.2 (for use only in HP EliteBook 750/850) 786035-001
32-GB, SSD 743008-001
Before removing the solid-state drive module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the service cover (see
Service cover on page 51).
5. Disconnect the battery.
Remove the solid-state drive:
1. Remove the Phillips PM2.0×3.0 screw (1) that secures the drive to the computer.
56 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
To Next Page
Loading...
