Solid-state drive (SSD)
Table 5-2 Solid-state drive descriptions and part numbers
Description Spare part number
1 TB, PCIe, TLC L62304-001
512 GB, PCIe, TLC L62301-001
512 GB, PCIe, Self-encrypting drive (SED), Opal 2, TLC L62303-001
512 GB, SATA-3, FIPS-140–2, TLC L62767-001
512 GB, PCIe, value L62302-001
512 GB, PCIe + 32 GB Optane™ Memory L63374-001
256 GB, PCIe, NVMe, TLC L62298-001
256 GB, PCIe, NVMe, value L62299-001
256 GB, SATA-3, Opal 2, TLC L62300-001
128 GB, SATA-3, TLC L62297-001
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 34).
2. Remove the bottom cover (see Bottom cover on page 34).
3. Disconnect the battery cable from the system board (see Battery on page 46).
Remove the solid-state drive:
1. Remove the Phillips M2.0 × 2.0 screw (1) that secures the drive to the system board.
2. Remove the drive by pulling it away from the connector (2).
IMPORTANT: When replacing the solid-state drive, remove the shielding from the old drive and install
it on the replacement drive.
Reverse this procedure to install the solid-state drive.
36 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
To Next Page
Loading...
