15. On the back of the display panel, lift the tape from the connector (2), and then disconnect the display
cable from the rear of the panel (3).
The raw display panel is available using the following spare part numbers:
FHD panel, non-touch, 400 nits: L62772-001
FHD panel, non-touch, 250 nits: L62773-001
FHD panel, non-touch, privacy: L62774-001
FHD touch-on panel (TOP), privacy, 250 nits: L62771-001
NOTE: The display back cover spare part kit includes four foam pieces. If replacing a privacy panel,
install the four foam pieces onto the inside of the display back cover, using the tick marks for placement.
Do not use the foam pieces for non-privacy panels.
Component replacement procedures 73
To Next Page
Loading...
