17. If it is necessary to replace the camera/ambient light sensor cable, disconnect the cable from the
ambient light sensor board (1), from the left (2) and right (3) sides of the IR camera, and then remove
the cable from the display enclosure (4).
The camera cable is available in the Cable Kit using spare part number L14370-001.
18. If it is necessary to replace the WLAN antenna cables, peel the antennas from the top of the display
enclosure (1), remove the antenna cables from the routing path on the bottom of the display enclosure
(2), and then remove the antenna cables (3).
NOTE: The WLAN antennas are spared with the display enclosure.
74 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
