Speaker assembly
Description Spare part number
Speaker assembly (includes cable) 730798-001
Before removing the speaker assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Battery on page 53), and then remove the following components:
a. Service cover (see
Service cover on page 51)
b. Battery (see
Battery on page 53)
c. Hard drive (see
Hard drive on page 54)
d. WWAN module (see
WWAN module on page 61)
e. WLAN module (see
WLAN module on page 63)
f. Fan (see
Fan on page 79)
g. Keyboard (see
Keyboard on page 65)
h. Base enclosure (see
Base enclosure on page 73)
i. System board (see
System board on page 90)
Remove the speaker assembly:
1. Position the top cover upside down.
2. Remove the two Phillips PM2.0×3.0 screws (1) that secure the speaker assembly to the base enclosure.
96 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
