14. If it is necessary to replace the hinges and hinge covers:
a. Release the display panel cable and the microphone cable from the display hinge cover on
the display left hinge (1).
b. Release the webcam cable (when applicable) and the wireless antenna cables from the
display hinge cover on the display right hinge (2).
c. Release the display panel cable and the webcam cable (when applicable) from the clips
and routing channel built into the display enclosure (3).
d. Remove the four Torx T8M2.5×6.0 screws (1) that secure the display panel to the display
enclosure.
e. Lift the top edge of the display panel (2) until it rests at an angle.
f. Lift the display panel (3) straight up and remove it.
g. Remove the eight Phillips PM2.0×4.0 screws (1) that secure the hinges to the display
panel.
82 Chapter 4 Removal and replacement procedures
Downloaded from LpManual.com Manuals
To Next Page
Loading...
