11. Remove the display assembly (2).
12. If it is necessary to replace the display bezel or any of the display assembly internal
components:
a. Remove the six rubber screw covers (1) that conceal the display bezel screws. The rubber
screw covers are included in the Display Rubber Kit, spare part number 596049-001.
b. Remove the six Torx T8M2.5×8.0 screws (2) that secure the display bezel to the display
assembly.
c. Flex the inside edges of the top edge (1), the left and right sides (2), and the bottom edge
(3) of the display bezel until the bezel disengages from the display enclosure.
ENWW Component replacement procedures 77
To Next Page
Loading...
