9. Release the webcam cable (when applicable) and the wireless antenna cables from the clips (3)
built into the top cover.
CAUTION: Support the display assembly when removing the following screws. Failure to
support the display assembly can result in damage to the display assembly and other device
components.
NOTE: When installing the display assembly, be sure the grounded sections of the webcam
cable (1) and wireless antenna cables are securely routed through the clips (2) and routing
channels built into the base enclosure.
10. Remove the two Torx T8M2.5×8.0 screws (1) that secure the display assembly to the computer.
76 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
