2. Remove the six Phillips M2.0×2.5 screws (3) that secure the hinge cover to the top cover.
3. Turn the computer right side up, with the front toward you.
4. Open the computer.
5. Rotate the display assembly (1) clockwise until it is perpendicular to the computer body.
6. Detach the left (2) and right edges of the hinge cover from the computer.
7. Remove the hinge cover (3) by sliding it away from the computer.
8. Remove the hinge cap (4).
Reverse this procedure to install the hinge cover and hinge cap.
Component replacement procedures
59
To Next Page
Loading...
