4. Place the I/O connectivity base onto the bottom of the stand (1), and then tighten the four screws on the
underside of the I/O connectivity base (2) to secure the I/O connectivity base to the stand. Be sure that
the USB Type-C power cable is routed through the gap between the back of the I/O connectivity base and
the stand.
5. To connect and secure the USB Type-C power cable, attach the cable clip to the cable (1), insert the cable
tie into the hole (2) below the USB Type-C port on the hub, and then slide the cable clip onto the cable tie
and connect the cable to the port (3).
6. Connect the I/O connectivity base’s AC adapter to the I/O connectivity base and a grounded AC outlet.
Attaching an I/O connectivity base to the Engage One 21
To Next Page
Loading...
