3.
Following the 1, 2, 3, 4, 5, 6, 7 sequence stamped into the fan/heat sink assembly, loosen
the seven captive Philllips screws (2) and (3) that secure the fan/heat sink assembly to
the system board, and then remove the fan/heat sink assembly (4).
NOTE: Due to the adhesive quality of the thermal material located between the fan/heat sink
assembly and the system board components, it may be necessary to move the fan/heat sink
assembly from side to side to detach it.
NOTE: The following illustration shows the fan/heat sink assembly removal process for a
computer model equipped with an AMD processor. The process for removing the fan/heat sink
assembly on a computer model equipped with an Intel processor is identical.
NOTE: Steps 4 and 5 apply to computer models equipped with a graphics subsystem with UMA
memory. See steps 2 and 3 for fan/heat sink assembly removal information for computer models
equipped with a graphics subsystem with discrete memory.
4. Disconnect the fan cable (1) from the system board.
84 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
