8. If you need to remove the display hinges, remove the 5 Phillips PM2.5×3.0 screws (1) that secure
each hinge to the display , and then lift the hinge off the display (2).
The display hinges are available using the following spare part numbers:
●
725448-001: Non-touchscreen models
●
725449-001: Touchscreen models
9. If you need to replace the webcam module, disconnect the webcam cable (1), and then lift to
disengage the adhesive that secures the webcam (2) to the display enclosure.
The webcam module is available using spare part number 725465-001.
10. If you need to remove the raw display panel, remove the 4 Phillips PM 2.0x3.0 screws (1) that
secure the panel to the display enclosure, and then rotate the panel upward (2) to gain access to
the display cable connection on the back .
60 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
