23
3.6.2 Using car’s battery with ACC cable connected.
• Motion Detection:
- In normal loop recording mode, press and hold POWER for 3
seconds, The screen will show message “Press OK to power off or
enter Motion Detection after 10 sec.”
- To disable this function, press any key to wake up the screen, and
resume to normal loop recording; or when the car engine is started
again, manually power off and power on the car camcorder, it will
be back to normal loop recording.
• Vibration Detection:
- Not available for this function
3.6.3 Connect with power bank
• Motion Detection:
- In normal loop recording mode, unplug car adapter and connect
power bank, press and hold POWER key for 3 seconds, The
screen will show message “Press OK to power off or enter Motion
Detection after 10 sec.”
- To disable this function, press any key to wake up the screen, and
resume to normal loop recording; or when the car engine is started
again, unplug the power bank, and connect car adapter, it will be
back to normal loop recording.
• Vibration Detection:
- Not available for this function
To Next Page
