HP HP-11C - Using (Sst)And Inprogrammode

100 Section 6: Program Editing
Keystrokes
22
©
SST
H
ST
)] S
-
ST
wn
ST
wn
ST
SST
Display
22.0000
9
001-42,21,15
9.0000
002- 4311
81.0000
003- 34
22.0000
004- 4311
484.0000
005- 40
565.0000
006- 11
23.7697
007- 43 32
23.7697
Load a into the Y-register.
Load b into the X-register.
While is held,
keycode in line 001 (for
(E)) is displayed.
When [SST]is released, the
label in line 001 is
executed.
Keycode for [+7].
released,
executed.
Keycode for [x=y].
executed.
executed.
executed.
executed.
executed.
Program completed;
calculator returns to line
000 and halts.
Note: will not advance into unoccupied lines of
program memory. If you single-step from the last occupied
line of program memory, and the last instruction is not
(go to) or (GSB](go to subroutine), the calculator will “wrap
around’’ to line 000. If the last instruction is a [(GTO]or
the calculator will execute the or instruction by
moving to the designated position in program memory.
Using and [BST]in Program Mode
Line by Line Stepping Through Program Memory. In
Program mode, when you press and release [SST], the calculator