HP HP-11C User Manual

134 Section 9: The Index Register
3. After 25 even numbers (2-50) and their squares are displayed,
the current counter value finally increments beyond 50. This
causes the calculator to skip one line after the at line
16. As a result, the 1 command at line 17 is bypassed
and the command at line 18 is executed, causing the
calculator to return to line 000 and halt.
After running the program, press[f][FIX]5, then[RCL](1]. Therecalled
I-register value in your display should now look like this:
5205002
Current Test Increment
Counter Value Value
Value
(nnnnn) (xxx) (yy)
Press 4 to return the calculator to 4 display mode.
ISG and DSE Limits. Note that and can be used to
increment and decrement any number that the calculator can
display. However, the decimal portion of the loop control value will
be affected by current counter values exceeding the five-digit nnnnn
value.
For example, the number 99,950.50055, when incremented using
would become 100,005.5006. The initial number was
incremented by 55. But since the new number 100,005.50055,
cannot be fully displayed, the decimal portion of the number was
rounded. As the calculator assumes a two-digit number for the
increment value (yy), the next increment would be by 60, not 55.
And when the number becomes 999,945.5006, the next number
would be 1,000,005.501, thus rounding the decimal portion of the
number again. Since no increment value yy is present, the next
increment would default to 01 instead of remaining at 60.
Direct R| Operations
Example ]
To Execute Keystrokes Display
Store in R, 12345 12,345
[sTo)() 12,345.0000

HP HP-11C Specifications

General

Brand	HP
Model	HP-11C
Category	Calculator
Language	English