TABLE OF CONTENTS (CONTINUED)
Section Page
5-68 Y Gear Train Backlash
Adjustment ..................................... 5-10
5-70 Y-Axis Pen Carriage
Adjustment ..................................... 5-10
5-72 Y-Axis Alignment ............................... 5-11
5-74 X-Axis Cable Tension Check/
Adjustment ..................................... 5-11
5-77 X-Axis Drive Belt Tension
Check/Adjustment .......................... 5-11
5-80 X-Axis Drive Belt Replacement........... 5-11
5-82 X Gear Train Backlash
Adjustment ..................................... 5-13
5-84 X-Axis Track Bearing
Adjustment ..................................... 5-13
5-86 X-Axis Drive Train Bearing
Replacement ................................. 5-13
5-91 Electrical Adjustments........................ 5-14
5-92 Gain Adjustment ............................... 5-14
5-94 Calibration Adjustment....................... 5-14
5-96 Phase Shift Adjustment ..................... 5-15
VI PARTS LIST
6-1 Introduction ....................................... 6-1
6-3 Parts List ........................................... 6-1
Section Page
6-4 Alphanumerical Table ....................... 6-1
6-6 Miscellaneous Parts .......................... 6-1
6-8 Recommended Spares ..................... 6-1
6-10 Code List of Manufacturers ............... 6-1
6-12 Illustrated Parts Breakdown................ 6-1
VII TROUBLESHOOTING
7-1 Introduction ....................................... 7-1
7-2 Content ............................................ 7-1
7-4 Troubleshooting ................................ 7-1
7-5 Requirements.................................... 7-1
7-7 Troubleshooting Index........................ 7-1
VIII BACKDATING
8-1 Requirements ................................... 8-1
8-2 Definitions ........................................ 8-1
8-4 Change I .......................................... 8-1
8-6 Change II .......................................... 8-3
8-8 Change III ......................................... 8-3
8-10 Change IV ......................................... 8-4
8-12 Change V ......................................... 8-4
8-14 Change VI ........................................ 8-7
8-16 Change VII ....................................... 8-7
APPENDIX A REFERENCES ................................. A-1
B MAINTENANCE ALLOCATION.......... B-1
iv
To Next Page
