HP HP-97 - Page 46

Assembly-Level Maintenance
3=-20
To replace the card reader assembly,
first remove the card reader cable
using the connector tool as in step
6b.
Place the card reader installation
tool (part number T-155239) into the
card reader cable slot as shown.
Place the card reader assembly onto
the support plate straddling the
tool as shown, and insert screws
into the slots of the three feet of
the card reader support.
Rotate the card reader assembly
clockwise to position the two feet
against opposite sides of the long
arm of the tool.
Tighten the three screws while
holding the card reader assembly in
the position described in step f.
Insert the card reader cable into
the connector as in step 6b.
HP-97