52
Running dce_config to Configure Enhanced DFS
Configuring a DFS Fileset Location Database
Configuring a DFS Fileset Location Database
Each cell that uses DFS requires at least one Fileset Location Database
(FLDB) server. If you are configuring a DFS System Control server, you
should do so before configuring the DFS FLDB server.
When you configure an FLDB server, a File server can also be configured
automatically, depending on the setting of the
CONFIG_DFS_FLDB_ONLY environment variable. A setting of "no"
(default) causes a File Server to be automatically configured; "yes" causes
only an FLDB server to be configured; if the environment variable is not set,
a prompt appears asking if you want to configure a File server in addition to
the FLDB.
NOTE: Set the CONFIG_DFS_FLDB_ONLY environment variable before starting
dce_config if you want to configure only the FLDB without the File server.
To configure an FLDB server, perform the following steps:
1 From the Additional Server Configuration Menu, choose 6 (DFS Fileset Location
Database Server):
Additional Server Configuration Menu (on hostname)
selection: 6
S:****** Configuring DFS Fileset Location Database
Server...
Enter Cell Administrator’s principal name:(cell_admin)
Enter password:
Should LFS be initialized (y)? y
S:****** Modifying the registry database for DFS server
operation...
>>> group member added
Current site is: registry server at
/.../test_cell/subsys/dce/sec/master
Domain changed to: group
Current site is: registry server at
/.../test_cell/subsys/dce/sec/master
Domain changed to: group
To Next Page
Loading...
