HP j6750 - Page 58

58
Running dce_config to Configure Enhanced DFS
Configuring a DFS Client
Enter Cell Administrator’s principal name:(cell_admin)
Enter password:
4 Choose whether the cache is in system memory or on the local disk.
Is the cache:
1. in memory
2. on the local disk
selection:
S:****** Starting dfsbind...
Step 5 assumes you choose 1 (in memory).
5 Choose a cache size for the memory. The default cache size is 1MB.
Enter the RAM size of the cache (1000):
Continue with Step 8.
Steps 6 and 7 assume you choose 2 (on the local disk).
6 Choose a cache size. The default cache size is 10MB. At least 10 MB of free disk
space must be reserved for on-disk cache.
Enter the size of the cache (10000):
7 Choose a directory to hold the cache (the default directory is a reasonable choice):
Enter the name of the cache directory
(/var/opt/dce/adm/dfs/cache):
S:****** Starting dfsd...
dfsd: start sweeping disk cache files...
dfsd: All DFS daemons started
8 Choose whether to configure an NFS/DFS Gateway. See Chapter 1 in the
Planning and Configuring HP DCE 1.7 manual for information about the
NFS/DFS Gateway.
Would you like to configure this DFS client as an NFS
Gateway (n)? y