1
HP Switch v2 zl Modules
HP Switch v2 zl Modules
For the HP E5400 zl and E8200 zl Switches
Descriptions. The HP Switch v2 zl Modules are the second generation zl
modules and provide a variety of improved network connectivity options for
any of the HP E5400 zl or E8200 zl switches. The following modules are
currently available.
Compatibility Mode allows the inter-operation of v2 zl modules with the older
zl modu
les in the same chassis switch. When in Compatibility Mode, the switch
accepts either v2 zl or zl modules. The default is Compatibility Mode enabled.
If Compatibility Mode is disabled by executing the “no allow-v1-modules”
command, the switch will only power up v2 zl modules. For more information
refer to the “Enhancement titled ‘Compatibility Mode’ in the latest Release
Notes for your switch”.
Module Description
HP 24-port Gig-T PoE+
v2 zl Mo
dule (J9534A)
1
24 twisted-pair ports with RJ-45
connectors for 10/100/1000Base-T
operation over Category 5 or better
100-ohm UTP or STP cable
(category 5e recommended for
Gigabit). All ports have the IEEE
802.3ab Auto MDI/MDI-X (HP
Auto-MDIX) feature and support
IEEE 802.3at PoE+.
HP 20-port Gig-T PoE+
/
4-port SFP v2 zl
Module (J9535A)
1
20 twisted-pair ports with RJ-45
connectors for 10/100/1000Base-T
ports that support PoE+ and 4 ports
for installing any of the supported
HP transceivers. All RJ-45 ports
have the IEEE 802.3ab Auto MDI/
MDI-X (HP Auto-MDIX) feature
and support PoE+. The mini-GBIC/
SFP ports do not support IEEE
802.3at PoE+.
To Next Page
Loading...
