Need help?Do you have a question about the HP J9982A and is the answer not in the manual?
General| Model | HP J9982A |
|---|---|
| Category | Switch |
| Uplink Ports | 4 |
| Power over Ethernet (PoE) | Yes |
| Jumbo Frame Support | Yes |
| Form Factor | Rack-mountable |
| Power Supply | Internal |
| Product Type | Switch |
| Operating Temperature | 0°C to 45°C (32°F to 113°F) |
| Operating Humidity | 10% to 90% non-condensing |
| Ports | 48 x 10/100/1000 |
| MAC Address Table Size | 16000 entries |
Explains how to physically connect the switch to a network and prepare for management.
Guides users through the initial steps of accessing and navigating the switch's web interface.
Provides instructions for logging into the switch management interface using default credentials.
Describes the structure and key elements of the switch's web interface for navigation.
Configures network interface settings like IP address, subnet mask, and gateway for switch management.
Manages port operation, status, settings, and traffic statistics.
Displays accumulated traffic statistics for each port and trunk.
Configures traffic monitoring by copying port traffic to a destination port.
Explains Spanning Tree Protocol (STP) for preventing network loops.
Detects and mitigates network loops using automatic protection mechanisms.
Manages VLANs, displaying status and allowing creation of new VLANs.
Assigns ports and trunks to specific VLANs and configures tagging.
Manages link aggregation groups (trunks) for increased fault tolerance and bandwidth.
Configures global LLDP parameters and port-level transmit/receive functions.
Configures LLDP-MED settings for enhanced network device discovery.
Details the PoE and PoE+ standards supported and port capabilities.
Sets global PoE power management modes and status.
Enables and configures built-in DoS and storm control protections.
View system messages, events, faults, and configuration changes stored locally.
To Next Page
